Architectural finishes and commercial window film in Fort Myers and Lee County, from condo towers to corporate lobbies.
Fort Myers work, surface by surface.
Impact and storm glazing
Bonds the pane so broken glass stays in the frame; we confirm the specification rather than quoting a brochure rating.
Heat gain and fading
Southwest-facing glass drives cooling load and fades everything behind it.
Condo tower cabs
Cab walls, doors and surrounds resurfaced without pulling the car – a shift, not a season.
Lobby and corridor finishes
Common areas refinished in place while residents keep using the building.
Corridor and unit doors
Class A fire-rated film over the doors already hung.
Anti-graffiti film
A sacrificial layer over glass, mirror and metal in public-facing areas.
Pier 66
Fort Lauderdale, Florida
Walls, Elevators
Amrit Ocean Resort
Riviera Beach, Florida
Disney Contemporary Resort
Hard Rock
Morgan & Morgan
Visit Orlando
Orlando, Florida
Woolpert
Hundreds of patterns, specified and installed.
Work from elsewhere in the state.
The people who call us in Fort Myers.
Architects
Specification support and samples.
Designers
Hundreds of finishes to design against.
Builders
A value-engineered alternative on the schedule.
Healthcare
Anti-microbial, fire-rated, occupied-building work.
Hospitality
Refresh guest-facing surfaces between seasons.
Commercial Office
Lobbies, corridors, cabs and casework.
Frequently asked questions.
What does security film actually do in a storm?
It bonds the glazing so that broken glass stays in the frame rather than entering the room, against impact, storms and forced entry. There are a lot of exaggerated claims about security film, so we confirm the specification for your glazing and your building rather than quoting a rating off a brochure.
What area do you serve?
We work throughout Florida, statewide, from single-site jobs to multi-building campuses.
Can one contractor handle the finishes, the glass and the window film?
Yes. We self-perform the whole interior surface package, walls, ceilings, columns, elevator cabs, doors, millwork, casework and glass, alongside commercial window film, decorative glass film, safety and security film and anti-graffiti film. Our own team installs all of it, so a lobby, its cabs and its glazing run on one schedule under one contractor instead of being split across trades.
What surfaces can architectural film go on?
Walls, ceilings, furniture, elevators, columns, doors, millwork, casework and glass. The surface needs to be smooth, solid and non-porous.
How well does the material stand up to wear?
Architectural finishes resist water, dirt and normal wear well, and can be cleaned with a non-abrasive cleaner or hot water. If the material does chip or scratch it can be repaired so that you cannot tell where the patch is.
How much can I expect to save?
Clients typically save up to 60% on an architectural finishes project compared with tearing the surface out and replacing it. The exact figure depends on the surface, the substrate and the size of the job, which is why the estimate is free.
How much does an estimate cost?
Estimates are completely free. Tell us the surface and the scope and we will come back with a real number, along with a sample of the finish.